Digital Point Finder :
Display in digital point finder mode on Large Colour graphics Display. The high image resolution provides a clear, sharp picture of the target directly on the display.
Single Pythagoras Measurement :
Just two measurements are enough to indirectly calculate the horizontal or vertical distances.
Double Pythagoras Measurement :
Using a tripod you can measure horizontal and vertical distances. The Leica DISTO™ determines the results for you out of three measurements. Functions such as minimum and maximum measurement help you find the correct measuring point.
Double Pythagoras Measurement (Chain Values) :
With just three measurements, you can also determine partial.
Tilt Measurement :
The tilt sensor of the Leica DISTO™ D5 measures inclinations of up to ± 45° and the DISTO™ D8 has a measuring range of 360°. That means with this device even overhead inclinations can be measured. This is especially interesting when determining roof slopes.
Horizontal Distance :
The tilt measurement allows you to determine the desired horizontal distance, even if the object cannot be directly targeted. This is particularly useful when obstructions like walls or hedges stand in the line of sight.
Trapezium Function :
The trapezium function is used to quickly and safely determine roof slopes and frontage areas, for example. You only need to take three measurements, and the result appears on the display.
Trapezium Function With Tilt Sensor :
If access to the object to be measured is limited and measurements can only be taken from one position, then this is no problem – thanks to the integral tilt sensor. This trapezium function can also be used to quickly and safely determine roof slopes and frontage areas.
Triangle Function :
The triangle function helps you quickly and efficiently to arrive at the area of a multi-cornered room. Divide the room into imaginary triangles. Then use three measurements to determine the areas of each of the triangles, which you can add together as you proceed. Finally all you have to do is read off the result.
Stake Out Function :
Two different distances (A and B) can be entered in the device and then be used to mark off defined measured lengths. At each measured length, the display shows the current marking distance and a direction arrow. Additionally, an alarm signal starts to ring at a distance of 0,1 m from the next stake out point.
